This fixation serves for the fastening of Taxom 800 price modules or Taxom 100 Price Label Frames on already existing blister hooks (double hooks or single hooks).
Installation on single hook:
At the rear end of the Taxom Display Hook Fixation there is a hole in the middle with about 10 mm.
Slide this hole onto the hook and fix it on the bottom side with the enclosed plastic screw.
Only suitable for single hooks with a wire diameter of 6 to 10 mm.
Installation on double hook:
At the rear end of the Taxom Display Hook Fixation there are two openings on the bottom side.
First, slide the holding fixture with the right opening on the right leg of your hole wall hook and then fix it on the left leg.
Only suitable for double hooks with a wire diameter of 3 to 5 mm and a centre-to-centre distance between the wire rods of 22,5 to 25 mm.
Dimensions:
Height top edge of double wire bracket to top edge of Holder: 22,5mm
Height top edge of simple wire bracket to top edge of Holder: 31mm
Colour of fixation: transparent
Fixation of the price module or the Price Label Frame on the Bar Clip 800:
Take the price module in the right hand and put it in the middle of the Clip with the left rear edge.
Then slide it into the perfect position with thumb and index finger.
With the Price Label Frames you have the additional possibility – due to the ribs on the backside – to fix them in various positions in the Clip (vertical or horizontal, in the middle, flush with upper or lower edge,…).
The Display Hook Fixation is available in the following lenghts: 10cm, 15cm, 20cm, 25cm, 30cm
The delivery is without Taxom 800 Price Module and without Frames.
